Braun Infusomat Space Instructions For Use Manual page 63

Chapter 6
Open the cover of the battery compartment (see ch. 1.12), unlock the battery by
sliding the green hook and pull out the battery using the metal handle.
Replace the Battery Pack SP in the battery compartment, lock it with the green
hook and test the proper placement by pulling the metal handle. Close the
battery compartment again.
Note:
the battery.
The battery is charged by the pump during connection to A/C power. When
disconnected from A/C or in case of power failure, the pump automatically
switches to battery power.
Connection to A/C power is displayed by the symbol
the pump. Recharging of WiFi battery while connected to A/C power and active
WiFi is ensured as long as environmental temperature outside Infusion pump is
35 °C (95°F).
Attention:
is recommended to fully charge the battery and store it at room temperature.
The status of the wireless connection is
displayed in the run screen. When the
wireless transmitter is switched off, no
symbol is shown in the status of the run screen.
If the wireless is activated, the status of the connection is shown.
Wireless operation mode is switched
on but no connection to the network.
Note:
contact your bio-medical engineering or IT department to determine cause.
Wireless operation mode is switched on
on and connection to the network is
established.
Further status information regarding the
status of the wireless connection can be
viewed in the Status menu.
Caution: The pump must be switched off before opening the battery
compartment.
In case of ESD, Pump may need to be plugged into wall outlet to re-start
If the battery module is stored for long periods of time outside the pump, it
Caution: Batteries may explode or leak if they are opened or
incinerated. Consider disposal directions!
An "X" through the wireless antenna indicates wireless connection has been lost,
BATTERY OPERATION AND MAINTENANCE
in the main menu of
63