Braun Infusomat Space Instructions For Use Manual page 52

Chapter 3
52
A stopwatch on the display counts down the remaining time (depending on the
service program, between 3-30 min). After that, the pump goes into an opera-
ting alarm.
Operating alarms:
Operating alarms immediately stop the infusion. An audible tone sounds, the red
LED flashes and a staff call is activated (optional). The display states "Alarm"
and the reason for the operating alarm. The alarm tone and message as well as
the staff call are turned off with K. Correcting the alarm state depends on the
cause of the alarm.
Display message
"VTBI infused "
"Time expired"
"Battery empty"
"Downstream occlusion"
"KVO time finished"
"Battery cover removed"
"Standby time expired"
"No battery inserted"
"Drive blocked"
"Calibrate device"
Alarm reason
The programmed volume was infused.
Hang new bag and/or reset VTBI
The programmed time has ended.
Hang new bag and/or reset time.
The battery is discharged.
The battery alarm will be on for 3 min.
Then the pump will automatically turn off. Plug
pump in immediately to re-charge battery.
The set downstream pressure level was exceeded. Post
occlusion bolus reduction is automatically initiated by
the pump.
Check tubing for kinks , closed stopcocks, filter
patency, and IV site.
Increase occlusion pressure if necessary per your
institutional policy.
The KVO time has ended. Program new settings.
The battery cover is not properly engaged on the
battery compartment.
Reposition cover, listening for click when battery
cover is locked in place.
The set standby time has ended.
Set new standby time or initiate infusion.
It is not possible to use the pump without a
battery.
Turn off pump and insert battery according
to directions in "Overview Infusomat® Space".
Excess pressure in system or motor failure. Remove
tubing and re-insert, if persists pump must be sent for
service.
Return to service for calibration.
ALARMS