Modem Setup Dialog Box For The Local Modem - Siemens SIMATIC S7-200 System Manual

Setting Up Communications Hardware and Network Communications
8. In the Communications Setup dialog box, double-click on the first modem icon.
The Modem Setup dialog box for the local modem appears (Figure 7-12).
9. In the Local Modem area, select your modem type. If your modem is not
listed, select the "Add" button to configure your modem. To do this, you must
know the AT commands for your modem. Refer to the documentation for your
modem.
10. In the Communications Mode area, select the communications mode (either
10-bit or 11-bit). The communications mode that you select depends upon
your modem capabilities. (The 10-bit and 11-bit communications modes are
described later in this section.) Both the local and the remote modem must
have the same communications mode. Click the "Configure" button.
Communications Links
Double click the icon representing the PLC
you
wish to communicate with.
Double click the interface icon to change to
communication parameters.
Double click the modem icon to setup the
Modem Setup
modem parameters or dial to start modem
communications.
Communication Parameters Local Modem
Remote Address:
Remote Modem
Local Address:
Module:
Protocol:
Transmission Rate:
Mode
Figure 7-12
7-18
Communications Setup
Bausch Induline IL 14K4 (11-bit)
2
0
PC/PPI cable (COM 1)
PPI
Add
9.6 bps
Communications Mode
Note: Both Local and Remote Modems must communicate using
the same communications mode.
10-Bit Communications
11-Bit Communications

Modem Setup Dialog Box for the Local Modem

PC/PPI cable
Address: 1
Bausch Induline IL 4K4
(11-bit, 9600 Baud, Predefined)
Connect Modem
 Â
(None Selected)
 Â
Remove...
Configure...
OK
S7-200 Programmable Controller System Manual
Double-Click
to Refresh
Cancel
A5E00066097-02