Operating The Shower - Triton T80si Installation And Operating Instructions Manual

Fig.
Power selector
High
Economy
Temperature
control
Note: In normal use, it is in order to leave the
water supply permanently on to the shower
N-002-A
unit, but as with most electrical appliances,
the unit must be switched off at the
isolating switch when not in use.
T80si electric shower
Cold
Stop
button


OPERATING THE SHOWER

OPERATInG THE SHOWER
WARNING!
Before normal operation of the
W-001-A
shower, it is essential the following
commissioning procedure is completed
correctly.
To start the shower
Press the START/STOP button and water will
flow.
To stop the shower
Press the START/STOP button and water will
cease to flow.
WARNING!
If restarting immediately after
W-003-A
stopping, be aware that a slug of hot
water will be expelled for the first few
seconds.
To use the power selector
The power selector has three positions — COLD,
ECOnOMy and HIGH — as shown in fig..
Blue symbol is for COLD water only. Adjustment
of the temperature control at this setting will
only alter the force of the water from the
showerhead. IT WILL nOT ALTER THE WATER
TEMPERATuRE.
Single red symbol is the ECOnOMy setting
for using less power when the ambient mains
water temperature is high during hot months.
At this setting adjust the temperature using the
temperature control.
Note: If the stated flow rate required for the unit
cannot be met due to low water pressure, it will
be necessary to operate the unit on this setting
during the warmer months because of flow rate
limitations entering the unit.
Double red symbol is the HIGH setting which
allows the highest flow achievable for your
preferred temperature. This setting should
normally be regarded as optimum shower
performance throughout the year. Temperature
adjustment at this setting is via the temperature
control.