Table of Contents
Advertisement
Power Shower
OPERATING THE SHOWER
Fig.27
Make sure all plumbing and electrical supplies
are connected and switched on.
To start the shower, press the start/stop button
(fig.27).
Adjust the flow control (fig.28) until the flow
rate is satisfactory.
For maximum flow, turn the flow control fully
clockwise. For minimum flow, rotate the flow
control fully anti-clockwise.
To adjust the water temperature, rotate the
temperature control clockwise for cold and anti-
clockwise for hot (fig.29).
Fig.28
To stop the shower, press the start/stop button
once more. This stops the pump and water flow.
The shower should be isolated from the
electricity supply after use, unless it is to be used
again immediately.
As a safety feature, the temperature control has
a built-in stop to prevent accidentally exceeding
your highest desired temperature. If adjustment
is required see section 'Temperature Control Set
up'.
To override this stop, press the button (fig.26)
while the control is up against the stop and
turn the control anti-clockwise to the higher
Fig.29
temperature settings. To return to the normal
temperature range just turn the temperature
control clockwise until it is past the maximum
temperature stop. Make sure that the
temperature control is in the normal temperature
range when the shower is switched off. The stop
comes in a factory set position based on water
supply temperatures in SPECIFICATION on
Pg.5.
Note: As the flow control is adjusted it is quite
normal for the sound of the pump to alter in
pitch.
18
Advertisement
Table of Contents
