Assembly - IDEAL Viceroy GT 8 Installation And Servicing

16 PREPARING THE REAR SECTION
1. Clean the nipple ports and nipples
with cleaning fluid.
2. Coat them with the lubricant
supplied with the sections.
3. Drive in the two nipples gently.
17 ASSEMBLING THE SPECIAL INTERMEDIATE SECTION
Note.
a. The section can be identified as having only three flueways.
b. This section must be positioned next to the rear section to ensure correct
flue gas path.
1. Place the special intermediate section onto the base frame. The arrow
marker points to the rear to denote the correct way to fit the section.
2. Fit the connections of the special intermediate section onto the nipples in
the rear section.
3. Ensure that the thermocord fits evenly between the sections in the correct
manner to make a good seal.
4. Hammer in with the help of a small wooden block.
5. For safety reasons, insert an upper assembly rod (body accessories
pack) into the holes in the sections.
6. Insert the assembly tool through the nipples and tighten.
18 ASSEMBLING THE INTERMEDIATE AND FRONT SECTIONS
1. Proceed likewise for other
intermediate and front sections.
2. Leave the assembly tool in place
after fitting the front section.
Viceroy GT -
Installation & Servicing
INSTALLATION
1
2
vic7090
5
3
6
vic7091
1
2
vic7092
3
3
1
2
4
15