IDEAL Viceroy GT 8 Installation And Servicing page 14

14 PREPARING THE BASE FRAME AND FITTING THE BASE INSULATION
1. Fit the 2 rear attachment brackets
(in the body accessories pack)
and attach them onto the
framework using two M12 x 40
bolts, four washers and two nuts.
Caution: use the corresponding
holes according to the indications
on the framework.
2. Put the lower insulation in place
(fabric to top) packs IE 51 to IE 57.
Adapt length if necessary or fold
the lower insulation after the
casing has been completely
assembled.
Note.
For pre-assembled boilers proceed
to Frame 27.
15 POSITIONING THE REAR SECTION
1. Determine the required location of the
framework depending on the direction in
which the burner door will be opened and the
length of the burner.
2. Place the rear section on the framework and
support it with a wooden block. Attach it at the
brackets using two M12 x 40 bolts, four
washers and two nuts.
3. Carefully put the thermocord in place (body
accessories pack) in the sealing groove and
cut to the correct length.
Note.
Do not pull on the cord when it is being put in, to
avoid stretching and to preserve its thickness.
14
INSTALLATION
1
GT 9, 11, 13
GT 8, 10, 12, 14
2
FRONT
2
M 12
M 12
vic7087
M 12
Viceroy GT -
REAR
3
2
Installation & Servicing