Advertisement
SAFETY
Current Gas Safety (Installation and Use) Regulations or
rules in force.
It is law that all gas appliances are installed and serviced by a
CORGI registered installer in accordance with the regulations
below. Failure to install appliances correctly could lead to
prosecution. It is in your own interest, and that of safety, to
ensure the law is complied with.
The following must be conformed with:
Current Building Regulations and Clean Air Act
Water Authority Regulations
Local Authority Regulations and Regional Bylaws
Gas Safety Regulations
Any special regional requirements of local Electricity and Gas
undertaking.
Fire Service and Insurance Company requirements.
In the interests of safety, a competent installer should be
employed to effect the installation of the appliance.
Manufacturer's notes must NOT, in any way, be taken as over
riding statutory obligations.
The installation of the boiler MUST also be in accordance with
the latest I.E.E. (BS7671) Wiring Regulations, local buildings
regulations, bye-laws of the local water authority, the building
regulations and the Building Standards (Scotland) and any
relevant requirements of the local authority.
Detailed recommendations are contained in the following
Codes of Practice:
BS 799 Pt4 & 7 Oil burning equipment.
BS 799 Pt5
Oil storage tanks.
BS 5410 Pt1
Installation for space heating and hot water
supply.
BS 5440
Installation and maintenance of flues and
ventilation for gas appliances of rated input
not exceeding 70kW net (1st, 2nd and 3rd
family gases).
Part 1
Specification for installation of flues
Part 2
Specification for installation and maintenance
of ventilation for gas appliances.
BS 5854
Flues and flue structures in buildings.
BS 5885 Pt1
Gas burners - with inputs 60kW and above.
Assembly and Installation Instructions for Ideal Falcon GTE heating boilers should be read in conjunction with the general
technical data tables enclosed and any other technical publication supplied with the burner.
NOTE TO THE INSTALLER: LEAVE THESE INSTRUCTIONS ADJACENT TO THE BOILER.
4
GENERAL
BS 6644
BS 6798
BS 6880
Part 1
Part 2
Part 3
BS 6891
EN 303.1
EN 303.2
EN 304
73/23 EEC
89/336 EEC
90/396 EEC
92/42 EEC
IGE/UP/1
IGE/UP/2
IGE/UP/10
SAFE HANDLING OF SUBSTANCES
Care should be taken when handling the boiler insulation
panels, which can cause irritation to the skin. No asbestos,
mercury or CFCs are included in any part of the boiler or its
manufacture.
Installation of gas fired hot water boilers of
rated input between 70kW and 1.8MW (net)
(2nd and 3rd family gases).
Installation of gas fired hot water boilers of
rated input not exceeding 70kW.
Low temperature hot water heating systems of
output greater than 45kW.
Fundamental and design considerations
Selection of equipment.
Installation, commissioning and maintenance.
Installation of low pressure gas pipework of up
to 28mm (R1) in domestic premises (2nd
family gas).
Heating boilers with forced draught burners.
General requirements.
Heating boilers with forced draught burners
with atomising oil burners.
Test code for heating boilers for atomizing oil
burners.
Low voltage directive. (Relevant standard is
EN60335.1)
Electromagnetic Compatibility Directive.
(Relevant standards are EN50081.1,
EN50082.1 and EN55014.)
Gas Appliances Directive. (Relevant standards
are EN303.1, EN303.2 and EN304.)
Boiler Efficiency Directive.
Soundness testing and purging of industrial
and commercial gas installation.
Gas installation pipework, boosters and
compressors on industrial and commercial
premises.
Installation of gas appliances in industrial and
commercial premises.
Falcon GTE -
Installation & Servicing
Advertisement
