IDEAL LOGIC Combi ES24 User Manual

IDEAL LOGIC Combi ES24 User Manual

Wall mounted, room sealed, condensing combination boiler
Hide thumbs Also See for LOGIC Combi ES24:

Advertisement

USER gUiDE
Logic CoMbI ES
ES24 ES30 ES35
For Installation Guide see reverse of book
When replacing any part on this appliance, use only spare parts that you can be
assured conform to the safety and performance specification that we require.
Do not use reconditioned or copy parts that have not been clearly authorised by Ideal.
For the very latest copy of literature for specification and maintenance practices visit our
website www.idealboilers.com where you can download the relevant information in PDF format.

Advertisement

Table of Contents
loading
Need help?

Need help?

Do you have a question about the LOGIC Combi ES24 and is the answer not in the manual?

Questions and answers

Summary of Contents for IDEAL LOGIC Combi ES24

  • Page 1 Do not use reconditioned or copy parts that have not been clearly authorised by Ideal. For the very latest copy of literature for specification and maintenance practices visit our...
  • Page 2: To Light The Boiler

    Benchmark Commissioning Checklist. You can check your installer by calling Gas Safe Register direct on 0800 4085500. Ideal stelrad group is a member of the Benchmark scheme and fully supports the aims of the programme. Benchmark has been introduced to improve the standards of installation and commissioning of central heating systems in the UK and to encourage the regular servicing of all central heating systems to ensure safety and efficiency.
  • Page 3: Operation

    Weather Compensation operation Winter conditions - i.e. Ch and DhW required. When the Weather Compensation option is fitted to the system then the CH Temperature Control (C) becomes a method of Ensure the mode knob control (D) is set to winter ( controlling room temperature.
  • Page 4: Condensate Drain

    Loss of system water pressure Condensate Drain The gauge (G) indicates the central heating system pressure. This appliance is fitted with a siphonic condensate trap If the pressure is seen to fall below the original installation system that reduces the risk of the appliance condensate pressure of 1-2 bar over a period of time then a water leak may from freezing.
  • Page 5: Troubleshooting

    See boiler “Operation Modes” section. If ‘0’ is displayed then provide central heating? and “Fault Codes” section contact Ideal Customer Services Helpline if your appliance is under warranty or a Gas Safe Registered Engineer, in IE a Check the time settings on the...
  • Page 6: Operation Modes

    OpERaTION MODEs DEsCRIpTION DIspLay CODE ON BOILER The boiler is in standby mode awaiting either a central heating call or hot water demand. The boiler has a call for central heating but the appliance has reached the desired temperature set on the boiler. The boiler has a call for hot water but the appliance has reached the desired temperature set on the boiler.
  • Page 7: Fault Codes

    5 Boiler Resets in 15 minutes 1. Turn power off and on at the fused spur. 2. If the boiler fails to operate please contact Ideal (if under warranty) or alternatively a Gas Safe Registered Engineer if outside of the warranty period.
  • Page 8 Ideal Consumer Helpline Ideal stelrad group pursues a policy of continuing improvement in the design and performance of its products. The right is therefore reserved to vary specification without notice. Tel: 01482 498660 Ideal, P.O. Box 103, National Ave, Kingston Upon Hull, HU5 4JN.

This manual is also suitable for:

Logic combi 35Logic 24Logic 30Logic 35Logic+ combi 24Es35 ... Show all

Table of Contents