IDEAL Viceroy GT 8 Installation And Servicing page 22

29 ASSEMBLING THE WIRING DUCTS AND FRONT TOP PANEL
1. Fit the left and right wiring ducts,
respecting the assembly direction
and attach each to the casing
support using one M5x12 bolt and
lock washer at each support.
2. Fit the cross pieces using two M5x12
bolts and lock washer.
3. Fit the front top panel and secure to
the wiring ducts using M5x12 bolts
and lock washers.
30 INSTALLING THE MAINS AND CONTROL WIRING
1. Route the mains supply in at the
rear, along one of the wiring ducts
and up through the opening in the
front top panel.
2. Route any remote sensor cables
similarly in the other wiring duct.
3. Secure the cables with the cable
ties.
22
INSTALLATION
3
2
1
1
vic7104
Viceroy GT -
Installation & Servicing
3
2