Built-In Analog Specifications; Analog Input; Analog Output - Mitsubishi Electric MELSEC iQ-F FX6U Hardware User Manual

2.7

Built-in Analog Specifications

The analog input/output specifications of the built-in analog function are explained below.
For details on the analog built-in function, refer to MELSEC iQ-F FX5 User's Manual (Analog Control - CPU module built-
in, Expansion adapter).

Analog input

Item
Analog input points
Analog input
Digital output
Device allocation
I/O characteristics, Maximum resolution
Accuracy
(Accuracy for the full scale of the digital
output value)
Conversion speed
Absolute maximum input
Insulation method
Occupied points
Terminal block used
*1 Products manufactured before June 2016 do not adapt to this specification.
*2 "Digit" refers to digital values.

Analog output

Item
Analog output points
Digital input
Analog output
Device allocation
I/O characteristics, Maximum resolution
*2
Accuracy
(Accuracy for the full scale of the analog
output value)
Conversion speed
Insulation method
Occupied points
Terminal block used
*1 There is a dead band near 0 V output, which is an area where some analog output values do not reflect digital input values.
*2 External load resistance is set to 2 kΩ when shipped from the factory. Thus, output voltage will increase somewhat if the resistance is
set higher than 2 kΩ. When the resistance is 1 MΩ, output voltage increases maximum 2%.
*3 Products manufactured before June 2016 do not adapt to this specification.
*4 "Digit" refers to digital values.
2 SPECIFICATIONS
40
2.7 Built-in Analog Specifications
Specifications
2 points (2 channels)
Voltage 0 to 10 V DC (input resistance 115.7 kΩ)
Unsigned 12-bit binary
SD6020 (Input data of ch1)
SD6060 (Input data of ch2)
Digital output value 0 to 4000
Maximum resolution 2.5 mV
Within ±0.5% (±20 digit
Ambient temperature
25 ±5
Ambient temperature Within ±1.0% (±40 digit
0 to 55
Ambient temperature Within ±1.5% (±60 digit
*1
-20 to 0
30 μs /channels (data refreshed every operation cycle)
-0.5 V, +15 V
Inside the CPU module and the analog input circuit are not insulated. Between input
terminals (channels) is not insulated.
0 points (does not pertain to the max. No. of input/output points of the CPU module.)
European-type terminal block
Specifications
1 points (1 channels)
Unsigned 12-bit binary
Voltage 0 to 10 V DC (external load resistance 2 k to 1 MΩ)
SD6180 (Output setting data of ch1)
*1
Digital input value 0 to 4000
Maximum resolution 2.5 mV
Ambient temperature Within ±0.5% (±20 digit
25 ±5
Ambient temperature Within ±1.0% (±40 digit
0 to 55
Within ±1.5% (±60 digit
Ambient temperature
*3
-20 to 0
30 μs (data refreshed every operation cycle)
Inside the CPU module and the analog output circuit are not insulated.
0 points (does not pertain to the max. No. of input/output points of the CPU module.)
European-type terminal block
*2
)
*2
)
*2
)
*4
)
*4
)
*4
)