Connection With A Personal Computer - Mitsubishi Electric MELSEC iQ-F FX6U Hardware User Manual

Connection with a personal computer

Connect the CPU module with a personal computer on which an engineering tool has been installed.
The system configuration examples and GX Works3 settings are described below.
For details, refer to GX Works3 Operating Manual.
Direct connection
Setting examples for accessing the CPU module that is directly connected with a personal computer are shown below.
■Ethernet connection
• CPU Module Direct Coupled Setting
Ethernet port
1)
GX Works3 settings
No. Item
1) PC side I/F
2) PLC side I/F
Other Station Setting
For the FX5 CPU module, the Ethernet adapter on the personal computer side used for the Ethernet port
direct connection can be specified.
Click the [CPU Module Direct Coupled Setting] button on the "Specify Connection Destination Connection"
window to display the "CPU Module Direct Coupled Setting" window. Select the adapter on the window.
• Connection via HUB
1)
GX Works3 settings
No. Item
1) PC side I/F
2) PLC side I/F
Other Station Setting
7 OPERATION ADJUSTMENT
164
7.1 Preparation for Operation
2)
Ethernet cable
Selection item
Ethernet Board
PLC Module
No Specification
Built-in Ethernet
(192.168.0.2)
HUB
2)
Selection item
Ethernet Board
PLC Module
No Specification
Built-in
Ethernet
Internal setting

Check at Communication Time
Retry Times
Internal setting

Connection via HUB IP Address
Response Wait Time
Check at Communication Time
Retry Times
Input value

Ethernet Port Direct Connection
30 seconds
0 times
Input value

192.168.0.2
2 seconds
30 seconds
0 times