Initial Test; Completion Of Installation - KAL-FIRE ECO-prestige 75 Installation Instructions Manual

30. Initial test

1 Test the Fairo ECO-prestige fire before completing the installation work on the surround.
2 Clean the glass panel(s) before lighting the fire for the first time. Fingerprints or other marks could have dirtied the glass, and
when burned, these marks can no longer be cleaned off.
3 Flush out the air from the gas supply regulator.
4 Light the Fairo ECO-prestige. There will be a delay before the flames appear during initial lighting due to the presence of air in
the gas pipe.
All Fairo ECO-prestiges are tested and lit in the factory.
The paint may still emit odours during the initial lighting of the Fairo ECO-prestige. These odours will disappear of their own
accord after a short period.
The paint does not completely harden until after a few uses.

31. Completion of installation

The Fairo ECO-prestige and the surround have different expansion rates. For this reason, to prevent cracks appearing in the
plasterwork or any other damage, ensure that the Fairo ECO-prestige and the surround are not touching each other (use a sealant
between the fire and the surround). The material used for the surround of the Fairo ECO-prestige must be heat resistant and
fireproof. There should be no combustible materials in the vicinity of the Fairo ECO-prestige. Any material, e.g. plasterwork or
wallpaper, used to decorate the wall (especially above the Fairo ECO-prestige) must be heat resistant.
No. 1+2: Make sure that curtains, furniture and/or other combustible materials are at least 100 cm from the Fairo ECO-prestige. If a
fireguard is used, this distance must be at least 40 cm.
69