System Messages When Exiting The Configuration Mode; System Messages During Operation - Siemens SIPART PS2 Operating Instructions Manual

10.1.3

System messages when exiting the Configuration mode

Remarks about the tables:
nn
/
Messages when exiting the configuration mode:
Message Line
Up Bot-
tom
n.nn.nn- X
nn
X
Error X
SLnn
X
10.1.4

System messages during operation

Remarks about the tables:
nn
/
Messages during operation
Message Line
Up Bot-
tom
CPU X
START X
HW / X
ERROR
NOINI X
nnn.n X
AUTnn X
SIPART PS2 with and without HART
Operating Instructions, 02/2016, A5E00074631-AB
Stands for variable numeric values
Error symbol
(slash): the texts on the left and right of the slash flash alternately
Operating mode
Automatic Manual mode
Stands for variable numeric values
Error symbol
(slash): the texts on the left and right of the slash flash alternately
Operating mode
Automat- Manual P manu-
ic mode al mode
X X
X
10.1 Output of system messages in the display
Meaning / cause
P manual mode
Software version
Monotony interruption
of the free character-
istic on the setpoint
turning point n
Meaning/cause
Message after application of
electrical auxiliary power.
Fault in the hardware.
X Positioner is not initialized.
Actual position [in %] for initial-
ized positioner. Flashing decimal
point shows communication with
a class 2 master.
Automatic mode (nn = setpoint)
Alarm, error, and system messages
Measure
Maintenance
•
Correct the value
•
Measure
Wait.
•
Replace electronics.
•
Start initialization.
•
205