Siemens SIPART PS2 Operating Instructions Manual page 41

1. Install the clamping pieces
2. Slide the pick-up bracket
3. Set the necessary length.
4. Tighten the screws
5. Fix the pre-installed carrier pin
6. Set the stroke value. Use the stroke value specified on the nameplate of the actuator for
SIPART PS2 with and without HART
Operating Instructions, 02/2016, A5E00074631-AB
⑰
socket cap screws
Figure 4-1 Pick-up bracket
⑰
⑭
washer and hexagon nut
Figure 4-2 Lever with carrier pin
this purpose. If none of the values on the lever scale matches the stroke value of the
actuator, select the next higher value on the scale. Position the pin center
corresponding value of the scale. If you need the value of actuator travel after
initialization in mm: ensure that the configured stroke value matches the value of the
"3.YWAY" parameter.
③
on the actuator spindle. Use spring lock washers
for this purpose.
②
into the milled recesses of the clamping pieces
so that you can still shift the pick-up bracket
④
to the lever
⑱
for this purpose.
4.2 Mounting the linear actuator
②
⑥
. Use the flat washer
Installing/mounting
⑯
and
③
.
.
⑫
, spring lock
④
on the
41