Dei-Nt Operation - DG Flugzeugbau DG-1000 Flight Manual

7.4 DEI-NT Operation

ignition switch
After turning on the main switch the DEI-NT shows a screen with operating
times.
Then the screen changes to the gliding screen (powerplant retracted) or to the
powered flight screen (powerplant not retracted).
You may change to other screens by pushing the selector knob (right hand side)
until the DEI_NT beeps twice.
The following screens may be selected:
1. Gliding or powered flight (according to powerplant position)
2. Flight log
3. Operating times
4. Set up
Description of the screens:
Caution: In case of powerplant failures and if warnings are necessary full
screen messages are displayed. All messages may be verified by a short push to
the selector knob, the DEI-NT changes back to the normal screen.
7.4.1 Gliding and powered flight screens
Upper left: Fuel level: If the fuel level falls short of approx. 4 litres the message
"Low Fuel" will be displayed,
DG-1000T: after verifying this message "R" is blinking.
DG-808C: after verifying this message the fuel level display is blinking,
when reaching the amount of non useable fuel (0,4 litres) "R" starts
blinking.
Lower left: Outside air temperature OA(T): When the OAT falls below 2°C the
message "Water Freeze" will be displayed, after verifying this message the
OAT display starts blinking.
Lower right: Battery voltage: Below a voltage of 11V the message "Low
battery" will be displayed, after verifying this message the voltage display
starts blinking. Above a voltage of 14,7V message "Battery Overch."will be
displayed, after verifying this message the voltage display starts blinking.
Lower centre: engine time for this flight
Issued: July 2017
Flight manual DG-1000T
TN1000/32
selector knob
7.10