Table of Contents
Advertisement
use the DOWN/UP button to select No (keep the present setting) or Yes (the fixture will reset to
factory settings and exit menu mode). To go back to the functions without any changes press the
MENU button again. Hold and press the MENU button for one second or wait for one minute to
exit the menu mode.
7. How to Control the Unit
7.1 DMX Connection
1. At last unit, the DMX cable has to be terminated with a terminator. Solder a 120-ohm 1/4W
resistor between pin 2(DMX-) and pin 3(DMX+) into a 3-pin XLR-plug and plug it in the
DMX-output of the last unit.
2. Connect the unit together in a "daisy chain" by XLR plug cable from the output of the unit to
the input of the next unit. The cable cannot be branched or split to a "Y" cable. DMX 512 is a
very high-speed signal. Inadequate or damaged cables, soldered joints or corroded connectors
15
Advertisement
Table of Contents
