Firmware Version - ACME ELLIPSOIDAL E-300 User Manual

Auto Test
To select the Auto Test, press the ENTER button to show AUTO TEST on the display .Use the
DOWN/UP button to select the Strobe or Dimmer Value mode. To go back to the functions
without any changes press the MENU button again. Hold and press the MENU button for one
second or wait for one minute to exit the menu mode.
Fixture Information
To select Fixture Information，press the ENTER button to confirm，Use the DOWN/UP button to
select the LED Temp.、Fixture Hours or Firmware version。
LED Temp.
To select the LED Temp., press the ENTER button to show LED TEMP. on the display, and the
display will show the temperature of the fixture. To go back to the functions without any changes
press the MENU button again. Hold and press the MENU button for one second or wait for one
minute to exit the menu mode.
Fixture Hours
To select the Fixture Hours, press the ENTER button to show FIXTURE HOURS on the display and
the display will show the number of working hours of the unit. To go back to the functions without
any changes press the MENU button again. Hold and press the MENU button for one second or
wait for one minute to exit the menu mode.

Firmware Version

To select the Firmware Version, press the ENTER button to show FIRMWARE VERSION on the
display and the display will show the version of software of the unit. To go back to the functions
without any changes press the MENU button again. Hold and press the MENU button for one
second or wait for one minute to exit the menu mode.
Factory Setting
To select the Factory Setting, press the ENTER button to show FACTORY SETTING on the display,
14