BDI format Assembly Instructions

Component List
F - Upper Horizontal Beam x 1
O - Back Panel x 1
Designed by Matthew Weatherly.
These distinctive product configurations are protected by US and
international patents, trade dress, and/or copyright laws.
BDI and Format are trademarks of Becker Designed, Inc.
All Rights reserved. ©2012, BDI
Made in Taiwan. 6301REV0111114v2
format
6301
desk
A - Phillips Screwdriver
x 1 (not provided)
B - 4mm Hex Wrench
x 1
C - Glides x 4
H - 1/4-20 x 1/2" Screw
x 14
J - Adhesive Foam /
Magnet x 4
Pre-installed on
Upper Horizontal
Beam (F)
M - M4 x 37mm
Phillips Screw
x 4
K - Pull x 2
-
D
a s s e m b l y i n s t r u c t i o n s
bdiusa.com
Format is engineered for easy assembly. Carefully follow this
procedure to prevent any damage.
Do not use power tools for assembly of this product.
Placement and Maintenance
Format™ Office furniture is designed for indoor use on level floors.
Clean steel parts and wood veneer with a moist cloth.
Step 1
Unpack and Identify
Unpack and identify the components at left. Note that some
components are shipped inside the cabinet. The assembly
workspace should be a non-marring surface such as carpet. For
missing hardware pieces, please contact BDI Customer Service
at customerservice@bdiusa.com. For all other concerns, please
contact your BDI Retailer.
G - Lower Horizontal
Beam x 1
Left Leg x 1
1
customerservice@bdiusa.com
I - Drawer Assembly x 1
-
E
Right Leg x 1
N - Front Kick Panel x 1
P -Center Drawer Liner x 1
Q -Side Drawer Liner x 2
-
K
Pull x 2