Ablerex MSRT-Pro 1KVA User Manual page 14

(6) Your start-up operation of the UPS is completely now as illustrated as
drawing E. Make sure the UPS is plugged onto the wall receptacle for
charging at least 4 hours and the batteries of the UPS are fully charged
4.4.2.2 Start-up in Battery Mode (Cold Start)
(1) Make sure the UPS has already been installed with batteries.
(2) Press the UPS On switch to awake the UPS for approx. 3 seconds, and
then the buzzer sounds twice.
Drawing A to drawing G.
G
(3) Press the UPS On switch of the UPS again for approx. 3 seconds till the
LCD display illustrates from drawing G to drawing H, then the UPS will be
in self-test Mode. The UPS may offer energy to the output in a minute,
and the LCD display illustrates as drawing I. In case of failure in pushing
the UPS On Switch in 10 seconds, the UPS will automatically turn off.
H
I
The LCD display will illustrate from
26
4.4.2.3 Check Measured Values & Figures detected by UPS
(1) If you would like to check the measured values & messages, please use
scroll up and scroll down
key pad, the LCD display will illustrate in sequence from Drawing E(Input
Voltage) Drawing J(Input Frequency)
Drawing L(UPS Output Frequency)
percentage) Drawing N(UPS Battery Voltage)
temperature
J
K
L
M
key pads. When you use scroll down
Drawing K(UPS Output Voltage)
Drawing M(UPS Output Load
Drawing O(UPS inner
27