Installing The Radio; Mounting And Removing The Control Head - Tait tm9100 p25 Installation Manual

Hide thumbs Also See for tm9100 p25:

Table of Contents

Installing the Radio

This section contains the following information:

■

For information on other types of installation, refer to

on page

the relevant sections in the service manual.

3.1

The control head and its connection loom are delivered separately from the

Mounting the

Control Head

radio body. Before installing the radio, the control head should be mounted

on the radio body.

The orientation of the radio body determines which way up the control

head is mounted on the radio body.

TM8100/TM8200 Installation Guide

mounting and removing the control head

selecting the mounting position

mounting the U-bracket

installing the antenna

connecting the power cable to the power source

connecting a remote speaker

connecting to the auxiliary connector (ignition signal,

emergency switch, external alert devices)

installing the radio

installing the microphone

checking the installation

29, the installation instructions provided with the equipment, and

Notice The control head contains devices which can be damaged by

static discharges. Always install or remove the control head in a static-safe

environment. For information on antistatic precautions, go to the Elec-

trostatic Discharge Association (ESD) website, http://www.esda.org.

Notice It may be necessary to mount the radio upside down to main-

tain a gap of more than 3/8 inch (10 mm) for air circulation between the

underside of the radio body and the mounting surface.

"Installation Options"

Installing the Radio

Table of Contents