Mounting The Radio - Tait TM9100 Installation Manual

2.3

Mounting the Radio

Introduction
Installation
16
The U-bracket included in the installation kit can be used to install the radio
on the dashboard or on any sufficiently flat surface (e.g. cabin floor or
trunk). The U-bracket can be mounted using the self-drilling screws and
washers provided, or nuts and bolts (not included).
Caution
Although an industrial-strength recloseable fastening system
can be used to support the installation, Tait does not
recommend this as a mounting option for safety reasons.
Important
When mounting the radio on a surface, check whether the
mounting screws will screw into material providing suffi-
cient strength. Reinforce the mounting surface, if required.
1. If the U-bracket is being mounted over a curved surface, the tabs at
the bottom of the U-bracket can be bent slightly to match the surface
shape.
2. Hold the U-bracket in the position chosen for the radio and use the
mounting holes as a template to mark the mounting locations.
The U-bracket must be installed using at least four screws.
Tip
The screws provided are self-drilling. For precise positioning, pilot
holes of ∅1/8 inch (3 mm) may be predrilled. Reduce the hole size
in metal that is less than 1/32 inch (1 mm) thick.
Important
Ensure that drilling at the selected points will not damage
existing wiring.
3. Drill any holes required for cables and fit the holes with suitable
grommets or bushings.
4. Fasten the U-bracket to the mounting points using the self-drilling
screws provided. Ensure that tightening the screws does not distort
the U-bracket.
5. Mount the radio to the U-bracket using the four thumb screws
provided. The radio can be tilted for the best viewing angle.
TM9100 (40W/50W) Installation Guide
© Tait Electronics Ltd October 2004