Tait TM9100 Installation Manual page 14

Figure 2.2 Disconnecting the control head from the radio body
Removing the Control Head
14
Important
During this procedure, take care that the control-head seal
is not damaged. Damage to this seal reduces environmental
protection.
1. On the underside of the radio, two lever points are indicated on the
radio body by a dot-dash-dot pattern (
between the control-head seal and the control head.
Important
When inserting the screwdriver, take care not to damage
the control-head seal.
2. At either of the lever points, insert a 3/16 inch (5 mm) flat-bladed
screwdriver between the control head and the control-head seal.
3. Use the screwdriver to lift the control head off the clip, then repeat in
the other position. The control head can now be removed.
lever point
control-head
seal
indication of
lever point
). The lever point is
TM9100 (40W/50W) Installation Guide
© Tait Electronics Ltd October 2004