Xconfiguration Video Output Connector [1] Overscanlevel; Xconfiguration Video Output Connector [1] Resolution; Xconfiguration Video Presentation Defaultsource; Xconfiguration Video Selfview Default Mode - Cisco TelePresence SX10 Reference Manual

Cisco TelePresence SX10

Introduction

xConfiguration Video Output Connector [1] OverscanLevel

Some monitors may not present the entire image that they receive. This means that the outer
parts of the image that is sent from the video system may be cut off when displayed on the
monitor.
Use this setting to instruct the video system not to use the outer part of the available frame.
This part might be cut off by the monitor. Both the video and messages on screen will be
scaled in this case.
Requires user role: ADMIN
Default value: None
USAGE:
xConfiguration Video Output Connector
where
: Unique ID that identifies the video output connector. Range: 1..1
n
: None/Medium/High
OverscanLevel
None: The video system will use all of the output resolution.
Medium: The video system will not use the outer 3% of the output resolution.
High: The video system will not use the outer 6% of the output resolution.

xConfiguration Video Output Connector [1] Resolution

Define the resolution and refresh rate for the connected screen. This value is fixed and cannot
be changed.
Default value: Auto
USAGE:
xConfiguration Video Output Connector
where
: Unique ID that identifies the video output connector. Range: 1..1
n
: Auto
Resolution
Auto: The system will automatically try to set the optimal resolution based on negotia-
tion with the connected monitor.
Cisco TelePresence SX10 API Reference Guide CE9.1, JUNE 2017.
D15333.07
About the API xConfiguration xConfiguration
n OverscanLevel: OverscanLevel
n Resolution: Resolution
xCommand

xConfiguration Video Presentation DefaultSource

Define which video input source to use as a default presentation source. This setting may be
used by the API and 3rd party user interfaces. It is not relevant when using the user interfaces
provided by Cisco.
Requires user role: ADMIN, USER
Default value: 2
USAGE:
xConfiguration Video Presentation DefaultSource:
where
: 2
DefaultSource
The video input source to use as default presentation source.

xConfiguration Video Selfview Default Mode

Define if the main video source (self-view) shall be displayed on screen after a call. The position
and size of the self-view window is determined by the Video Selfview Default PIPPosition and
the Video Selfview Default FullscreenMode settings respectively.
Requires user role: ADMIN, INTEGRATOR
Default value: Current
USAGE:
xConfiguration Video Selfview Default Mode:
where
: Off/Current/On
Mode
Off: self-view is switched off when leaving a call.
Current: self-view is left as is, i.e. if it was on during the call, it remains on after the call;
if it was off during the call, it remains off after the call.
On: self-view is switched on when leaving a call.
80
API Reference Guide
xStatus Appendices
DefaultSource
Mode
Copyright © 2017 Cisco Systems, Inc. All rights reserved.