Audio Configuration; Xconfiguration Audio Defaultvolume; Xconfiguration Audio Microphones Mute Enabled; Xconfiguration Audio Soundsandalerts Ringtone - Cisco TelePresence SX10 Reference Manual

Cisco TelePresence SX10

Introduction

Audio configuration

xConfiguration Audio DefaultVolume

Define the default volume for the speakers. The volume is set to this value when you switch on
or restart the video system. Use the Touch controller or remote control to change the volume
while the video system is running. You may also use API commands (xCommand Audio Volume)
to change the volume while the video system is running, and to reset to default value.
Requires user role: ADMIN, INTEGRATOR, USER
Default value: 50
USAGE:
xConfiguration Audio DefaultVolume:
where
: Integer (0..100)
DefaultVolume
Select a value between 1 and 100. This corresponds to the dB range from -34.5 dB to
15 dB, in steps of 0.5 dB. If set to 0 the audio is switched off.

xConfiguration Audio Microphones Mute Enabled

Define the microphone mute behaviour on the video system.
Requires user role: ADMIN, INTEGRATOR
Default value: True
USAGE:
xConfiguration Audio Microphones Mute Enabled:
where
: True/InCallOnly
Enabled
True: Muting of audio is always available.
InCallOnly: Muting of audio is only available when the device is in a call. When Idle it is
not possible to mute the microphone. This is useful when an external telephone service/
audio system is connected via the codec and is to be available when the codec is not
in a call. When set to InCallOnly this will prevent the audio-system from being muted by
mistake.
Cisco TelePresence SX10 API Reference Guide CE9.1, JUNE 2017.
D15333.07
About the API xConfiguration xConfiguration
DefaultVolume
Enabled
xCommand

xConfiguration Audio SoundsAndAlerts RingTone

Define which ringtone to use for incoming calls.
Requires user role: ADMIN, INTEGRATOR, USER
Default value: Sunrise
USAGE:
xConfiguration Audio SoundsAndAlerts RingTone:
where
: Sunrise/Mischief/Ripples/Reflections/Vibes/Delight/Evolve/Playful/Ascent/
RingTone
Calculation/Mellow/Ringer
Select a ringtone from the list.

xConfiguration Audio SoundsAndAlerts RingVolume

Define the ring volume for incoming calls.
Requires user role: ADMIN, INTEGRATOR, USER
Default value: 50
USAGE:
xConfiguration Audio SoundsAndAlerts RingVolume:
where
: Integer (0..100)
RingVolume
The value goes in steps of 5 from 0 to 100 (from -34.5 dB to 15 dB). Volume 0 = Off.
34
API Reference Guide
xStatus Appendices
RingTone
RingVolume
Copyright © 2017 Cisco Systems, Inc. All rights reserved.