Xconfiguration Sip Uri; Standby Configuration; Xconfiguration Standby Control; Xconfiguration Standby Delay - Cisco TelePresence SX10 Reference Manual

Hide thumbs Also See for TelePresence SX10:
Table of Contents

Advertisement

Cisco TelePresence SX10
Introduction

xConfiguration SIP URI

The SIP URI (Uniform Resource Identifier) is the address that is used to identify the video
system. The URI is registered and used by the SIP services to route inbound calls to the system.
The SIP URI syntax is defined in RFC 3261.
Requires user role: ADMIN
Default value: ""
USAGE:
xConfiguration SIP URI: "URI"
where
: String (0, 255)
URI
An address (URI) that is compliant with the SIP URI syntax.
Cisco TelePresence SX10 API Reference Guide CE9.1, JUNE 2017.
D15333.07
About the API
xConfiguration
xConfiguration
xCommand

Standby configuration

xConfiguration Standby Control

Define whether the system should go into standby mode or not.
Requires user role: ADMIN, INTEGRATOR
Default value: On
USAGE:
xConfiguration Standby Control:
where
: Off/On
Control
Off: The system will not enter standby mode.
On: The system will enter standby mode when the Standby Delay has timed out.
Requires the Standby Delay to be set to an appropriate value.

xConfiguration Standby Delay

Define how long (in minutes) the system shall be in idle mode before it goes into standby mode.
Requires the Standby Control to be enabled.
Requires user role: ADMIN, INTEGRATOR
Default value: 10
USAGE:
xConfiguration Standby Delay:
where
: Integer (1..480)
Delay
Set the standby delay (minutes).
69
API Reference Guide
xStatus
Appendices
Control
Delay
Copyright © 2017 Cisco Systems, Inc. All rights reserved.

Hide quick links:

Advertisement

Table of Contents
loading

Table of Contents