94 | Configuring the Traffic Interfaces
Configuring the Ethernet switch for VLAN tagging
1. Select Link or Local or Remote > Interface > Ethernet Settings.
Note: Always configure the remote terminal before the local terminal
2. In the Quick Links box at the bottom of the page, click Ethernet General Settings.
3. From Ethernet Grouping drop-down list select 'Enabled' ('Disabled' is the default setting; Ethernet
traffic is not segregated).
Important: Changing this setting will disrupt Ethernet traffic.
4. Click Apply to apply changes or Reset to restore the previous configuration.
You now need to select the VLAN groups for each of the four Ethernet ports.
Aprisa XE User Manual