4RF Aprisa XE User Manual page 19

Phase 4: Configuring the traffic
1. Confirm that the interface hardware and software slot configurations
match.
2. Confirm the interface card settings.
3. Open the Cross Connections application and configure the cross
connections:
Download the configuration.
Confirm or modify the traffic cross connections.
Save the configuration to the terminal.
Activate the configuration.
4. Save the configuration to disk and close the Cross Connections
application.
5. Connect the connection of interface cables.
6. Confirm or adjust the terminal clocking for network synchronization, if
required.
7. Test that the traffic is passing over the link as configured.
8. Confirm or configure the external alarm settings in SuperVisor.
9. Setup an external alarm connection cable, if required.
10. Reset any alarms and error counters.
11. Perform traffic pre-commissioning tests (optional)
12. Complete the commissioning form (at the back of the manual) and file.
Aprisa XE User Manual
Getting Started | 17
Page 92
Page 146
Page 155
Page 81
Page 244
Page 327