4RF Aprisa XE User Manual page 18

16 | Getting Started
Phase 3: Establishing the link
1. If you don't know the terminal's IP address :
Connect the setup cable between the terminal's Setup port and the PC
using accessory kit adaptor.
Use HyperTerminal to confirm the IP settings for the terminal:
Local IP address
Local subnet mask
Remote terminal IP address
Reboot the terminal
2. Connect the Ethernet cable between the terminal's 4-port Ethernet
switch and the PC.
3. Confirm that the PC IP settings are correct for the 4-port Ethernet
switch:
IP address
subnet mask
4. Confirm that Java is installed on the PC.
5. Start the web browser, and log into the terminal.
6. Set or confirm the RF characteristics:
TX and RX frequencies
Modulation type
TX output power
7. Compare the actual RSSI to the expected RSSI value (from your path
planning).
8. Fine-align the antennas.
9. Confirm that the terminal clock sources are set correctly.
10. Confirm that the TX and RX LEDs are green. Disregard the OK LED status
for now.
Aprisa XE User Manual
Page 58
Page 50
Page 49
Page 60
Page 69
Page 201
Page 73