Insignia NS-OTR16SS8Q Installation Manual page 24

5 Insert wood screw(s) through the mounting plate and into the hole(s) drilled in the stud(s), then tighten both the
wood screw(s) and toggle bolt(s) with a Phillips screwdriver to mount the plate. Make sure that the plate is
centered before tightening fully.
You'll need:
24
Caution
Be careful to avoid pinching your fingers between the back of the mounting plate
and the wall.
Toggle bolts
Mounting plate (Qty. 1)
(ships attached to microwave)
www.insigniaproducts.com
Toggle bolt
Toggle wing
Wall
Mounting plate
Wood screws
Phillips screwdrivers
NS-OTR16SS8Q