Step 2: Align The Rear Wall Template - Insignia NS-OTR16SS8Q Installation Manual

Step 2: Align the rear wall template

1 Use a level to make sure that the bottom of the cabinet is level.
2 Draw a vertical line down the center of the wall in the mounting space. This is where the center of your template
will be.
3 Draw a horizontal line at the height of the front of your cabinet. This is where the top of your template will be. If
the bottom of your cabinet is flat, make sure that you leave space for the power cord.
Flat bottom:
Cabinet
4 Trim the rear wall template along the dotted line.
Notes
If the rear wall template is damaged or unusable, measure and mark the wall with
the dimemsions at the end of this step.
Cabinet
Power cord
Rear wall template
Notes
• If installing the microwave beneath smooth, flat cabinets, make sure that you
leave enough space for the power cord clearance.
• If cabinets have decorative trim that interferes with the microwave installation,
remove the trim to install the microwave properly and to make sure that it is level.
www.insigniaproducts.com
1.6 Cu. Ft. Over-the-Range Microwave
Front overhang:
Cabinet
Recessed back:
Cabinet
11