Using The Power Key - Intermec CN2 User Manual

Chapter 1 — Using the CN2 Handheld Computer

Using the Power Key

The Power key is the round yellow key in the upper left corner
of both keypads.
Actions You Can Perform With the Power Key
Action Do This
To turn on the Press and release the
CN2 Power key.
To turn off the Press the Power key
CN2 for 2 to 3 seconds
and then release it.
To toggle the Press the Power key
backlight for 5 to 6 seconds
and then release it.
To warm boot the Press the Power key
CN2 for 10 seconds and
then release it.
(After 5 seconds, the
backlight toggles
(turns on or off).
Keep holding the
Power key for
another 5 seconds
until the backlight
flashes.)
Note: If your CN2 does not resume after you press the Power
key, your battery may be too low to supply power. Replace or
charge the battery. If replacing or charging the battery does not
solve the problem, see "Booting the CN2" on page 104.
14
Description
Your CN2 resumes where it was when you
turned it off. If you are using WPA or 802.1x
security, the computer may need to
reauthenticate before it starts your application.
Your CN2 enters Suspend mode. In Suspend
mode, the CN2 continues to supply power to
all memory, but turns off power to most
hardware. This power-saving feature is
designed to prolong battery life.
The CN2 backlight toggles (turns on or off)
but the CN2 continues running.
For details, see "Warm Booting the CN2" on
page 104.
CN2 Handheld Computer User's Manual