Deco (Fnc 41) - Mitsubishi FX1S Series Programming Manual

Hide thumbs Also See for FX1S Series:

Table of Contents

FX Series Programmable Controlers

DECO (FNC 41)

16 BIT OPERATION

Source data value

Q identifies the

Qth bit of the

destination device

which will be

32 BIT OPERATION

D= Y,M,S then n range =

D= T,C,D then

n range = 1-4

n= 0, then no

Source data is provided by a combination of operands

S and n. Where S specifies the head address of the

data and n, the number of consecutive bits. The

source data is read as a single number (binary to

decimal conversion) Q. The source number Q is the

location of a bit within the destination device (D) which

will be turned ON (see example opposite). When the

destination device is a data device n must be within

the range 1 to 4 as there are only 16 available

destination bits in a single data word. All unused data

bits within the word are set to 0.

Applied Instructions 5

Program steps

Table of Contents

Fx1n series Fx2nc series Fx2n series