Flashforge Creator Pro User Manual page 37

9. Profiles
Select it and then press OK, the display will indicate:
ABS
PLA
Profile1
Profile2
Select any option and press OK; the display will indicate:
Restore (Back to Utilities)
Display Config
Change Name
Save To Profile
Select Display Config and then press OK ; the display will indicate
Config
X Offset
Y Offset
Z Offset
Right Temp
Left Temp
Platform Temp
Change Name
Save To Profile
10.Home offsets
Select it and then press OK, the display will indicate:
X Offset
Up/Dn/Left/OK to Set (Press Up button and Down button to change the X/Y axis coordinate;
11. Toolhead Offsets
12. Jog Mode
Select it and then press OK, the display will indicate:
X+
(Menu) Y-









X-







13. Enable steppers
Select it and then press OK, the display will indicate:
Disable Steppers
Steppers is lock. It means the position of extruder or build plate cannot be manually adjusted.
Press OK button again to back to Enable steppers. It means the position of extruder or build plate
can be manually adjusted.
14. Auto-Level Adj
15. Auto-Level Variance
16. Max Z Probe Hits
Select it and then press OK, the display will indicate the distance build plate descending after
printing job completed.
press OK to confirm; press Left button to back.)
Press Right/Left button change the X/Y/Z axis interface;
press Up/Dn button to change the coordinate;
press OK button to back.
36