Flashforge Creator Pro User Manual page 35

Press page down key to select Left Extruder (or Right Extruder), press [OK] key, you will see ：
Start Preheating
Right Extruder
Left Extruder

















Platform
Press page up key back to Start Preheat, and Press [OK] key, you will see:
Heating
：
R Extruder 33/230℃
：
L Extruder 33/230℃
：
Platform：024℃
This means the left extruder is heating up, when it reaches 220°C. First push in the filament a little bit until
you see filament come out of the nozzle, press the spring presser then pull it out quickly. This will ensure
you have withdrawn the filament inside the nozzle successfully.
Then users should:
1. Insert your SD card with target x3g file to your Creator Pro. .
2. Turn on the Creator Pro.
3. Select [Print from SD] on the LCD panel.
4. Select the file you want to print and press [OK].
5. And the printer will heat up the nozzle and the build plate automatically and start to print after the
nozzle and the build plate reaches the aimed temperature.




ON
OFF
OFF
34