Flashforge Creator Pro User Manual page 29

Temperature
6.2.12 File Menus
1. New Project: Click [File]--[New Project] can build a blank project. If there is an unsaved
modification on previous project, then it will inform you whether the
modification needs to be saved or not. Click [Yes] will save the modification,
and then click [No] will abandon it. If click [Cancel] or close tool tip, then it will
cancel the new project.
2. Saving: After finishing the model edit and adjustment, there are two ways below to save all
models in the scene.
Method 1: Click [File]--[Save Project] in the menu bar to save the file as a project file
Shells Contains the outside shell value, capping layer value (under
vase mode, top solid layer setting is invalid.)
Perimeter Shells: Maximum is 10
Top Solid Layers: Maximum is 30, minimum is 1.
Bottom Solid Layers: Maximum is 30, minimum is 1.
Infill
Fill Density: Fill rate.
Fill Pattern: The pattern of filling shape which effects printing
Combine Infill: You can select the layers for combining
according to the layer thickness. The combined thickness
should not exceed 0.4mm. "Every N layers" is for all the infills
while "Every N inner layers" is only for inner infills, which
generally can save print time.
Speed Print Speed: The moving speed of the extruder. Generally,
the lower speed is, the better print you will get. For PLA printing,
80 is recommended.
Travel Speed: Control the moving speed of the extruder under
non-printing Status during work. For PLA printing, 100 is
recommended.
Extruder Temperature: Recommended extruder temperature
is 220℃. Note: Different temperatures have subtle influences
in prints. Please adjust the temperature according to the
condition in order to get a good print.
Platform Temperature: To set the temperature of Platform.
Others
Cooling Fan Control: Set up the time to turn on the cooling
fan. You can pre-set the height and make the cooling fan
begin to work at the point.
with the ".fpp" suffix, all models in the scene (include support) are
independent. If reloading the files, extruder configuration information and
model position will be the same as the configuration during saving.
28
duration.