Flashforge Creator Pro User Manual page 31

5. Duplicate: Select the object and duplicate the object through the following two methods:
Method 1: Click [Edit] - [Duplicate].
Method 2: Press the shortcut key Ctrl+V.
6. Delete: Select the object and delete the object through the following two methods:
Method 1: Click [Edit] - [Delete].
Method 2: Press the shortcut key Delete.
7. Auto Layout All: Click [Edit] - [Auto Layout All] after loading one or more than one models,
8. Repair Models: Recover model error.
9. Supports: Refer to Chapter6.2.10.
6.2.14 Tools
6.2.14.1 Update Firmware
Before updating firmware, you need to find and depress "driver-creator-pro" in the SD card.
Click and install the relevant installation program.
Launch the FlashPrint (Now your computer and Creator Pro are connecting with each other),
click [Tools] and [Update Firmware], then click [OK] and a dialog box will pop up. Click [Yes] to
start firmware update.
Machine Type:
Select Firmware:
Select Serial:
Sailfish Firmware 7.8 for FlashForge Creator Pro
?
6.2.15 Help Menus
1. First Run Wizard
2. Help Contents: Click [Help]--[Help Contents], you can read flashprint user guide.
3. Check for Updates: Click [Help]--[Check for Update] to detect the available updates online.
4. About FlashPrint: Click [Help]--[About FlashPrint], the software information box will pop up.
all models will be placed automatically as automatic placement rule.
Update Firmware
FlashForgr Creator Pro
ff_creatorx-2560_v7.8.0-Pro-20160523
Information
Upgrading firmware might interrupt the printer's task, ensure your
printer is in an idle state.
The contents include the current software version and copyright
information.
30
Rescan
OK Cancel
Yes No