Loading Filament - Flashforge Creator Pro User Manual

Next, we are going to print the model. Before printing, users should:
1. properly install the dual extruder.
2. properly install the filament guide tube.
3. properly mount the filament spool and feed the filament.
To make the process of feeding or withdrawing the filament easy, please follow the next few steps
carefully: After inserting the filament into the filament intake, do not push it further until the extruder
temperature reaches 200°C or higher. Once the machine reaches this point, you will feel the filament
being pulled into the extruder head.

Loading Filament

7 . 2
Turn on the Creator Pro; using the directional arrow buttons in the right of the screen, to select
Utilities and then press the [OK].
FF Creator Pro
Print from SD
Preheat
Utilities
Select Filament loading, press the [OK] key of the keypad.
Monitor Mode
Filament loading
Preheat Setting
General Settings
Select the appropriate side of the extruder you wish to load (Left or Right for models with dual
extruders). Press the [OK] key again on the keypad. The display will indicate: I'm heating up my
extruder!" At this time, the temperature of the right nozzle is being heated up. When the temperature
of the nozzle reaches its target temperature, pressing the [OK] key on the keypad, and the nozzle
should start extruding filament. If not, keep pressing the [OK] key until it does.
Unloading the Filament Using LCD Panel
7 . 3
CAUTION
!
If you want to withdraw the filament after just finishing your printing or extruding, first press down the
spring presser and push the filament in a little further, and then directly pull it out when the extruder
temperature is still over 200℃。
If you want to change another color filament, first you need to withdraw filament and then load in. Please
do as following shown to avoid filament jam.
Turn on the Creator Pro. Using the directional arrow buttons in the right of the screen, to select Utilities and
then press the [OK].
FF Creator Pro
Print from SD
Preheat
Utilities
Unload Right
Load Right
Unload Left
Load Left
Start Preheating
Right Extruder
Left Extruder
Platform
33
OFF
OFF













OFF