Wiring; Single Speed Wiring - QuietCool TRI PRO-1.5 Owner's Manual

4. WIRING

NOTE:
by an experienced electrician. 12 or 14-gauge romex is common. Check your local building
code before choosing the wire type.

4-1. Single Speed Wiring

For wiring of the TRI PRO-1.5 with one speed.
4-2. Two Speed Wiring
For wiring of the TRI PRO-2.5, 3.3, 4.8, and 5.5 with two speeds.
4-3. Four Speed Wiring
For wiring of the TRI PRO-6.5 with four speeds.
NOTE:
outlet, but will only operate on high speed. The system will also work with a wireless
system using the power cord. The main purpose of the power cord is to test fan
operation.
4-1 Single Speed Wiring (for TRI PRO-1.5)
1. For this installation, you will need (2) 2 wire Romex, single-gang retrofit box, and an 8 Hour Timer.
Using the included wire nuts, tie the black wire from the first 2 wire Romex from the power source to
the black wire on the timer. (see Figure A)
2. Using a wire nut, tie the black wire on the 2 wire Romex from the fan to the red wire on the timer.
3. Using a wire nut, tie the bare copper wires together with the green ground wire on the timer.
4. Using a wire nut, tie the white common wires from the Romex to the white common wire on the timer.
5. Begin wiring the fan by opening up the handy box. Take off the wire nuts within the handy box.
Unscrew the green ground wire. Detach the green ground wire from the power cord. Remove the
power cord. Re-attach the ground screw and wire to the handy box. Cut your green ground wire in
half and strip both sides. (see Figure B)
1-888-QUIETCOOL
Wiring Diagrams are for examples only and wiring should be done
QuietCool whole house fans can be used with the included power cord with a plug
13