Wiring; Wiring Gx Es-1100 With Thermostat - QuietCool GA ES-1500 Owner's Manual

3. WIRING

NOTE: Wiring Diagrams are for examples ONLY. Wiring should be done by an
! !
experienced electrician.
NOTE: Your fan may have come with the RF Hub or Thermostat pre-wired to a power cord for
! !
testing purposes before installation. The power cord can be used when installed inside of an attic.
DO NOT USE THE POWER CORD OUTDOORS. If you would like to hard-wire the fan, or it is
required by your local building codes, please follow the wiring instructions below.
3.1 GX ES-1100 WIRING WITH THERMOSTAT
1. Mount a junction box for your thermostat in the best location for thermostat readings which is
usually on the wall next to the light switch or garage door opener in the garage. Begin wiring the
thermostat.
2. With a 3 wire Romex, tie the black wire to the black wire from the thermostat.
3. Tape the white common wire on both sides of the 3 wire Romex because we will be using this as our
switch leg.
4. Tie the red wire and the taped white wire together.
5. Attach the ground wire to the ground screw on the timer.
6. In the fan's junction box, tie the black wire from the fan to the taped white wire.
7. Tie the two remaining black wires together. Then, tie the remaining copper wires together.
Figure 3.1A
Power
Source
8
Ground the fan to the junction box
using the green ground screw
Junction
Box
14-2 Wire
14-2 Wire
50 60 70 80 90
OFF
1-888-QUIETCOOL