Setting Up The Wireless Control; Wireless Control Wiring - QuietCool GA ES-1500 Owner's Manual

VERY IMPORTANT:
CLOSES EASILY. MAKE SURE TO SECURE THE LATCH IN THE OPEN POSITION (AS SHOWN IN FIGURE
2.1D)
AVOID BACKDRAFTS:
APPLIANCES IN THE GARAGE. QUIETCOOL GARAGE FANS MOVE LARGE QUANTITIES OF AIR.

3. SETTING UP THE WIRELESS CONTROL

NOTE: Wiring Diagrams are for examples ONLY. Wiring should be done by an experienced
electrician.
NOTE: Your fan may have come with the control pre-wired to a power cord. If this is the case,
simply mount the control box, find a power source in your attic, and plug the fan in. If you
would like to hard-wire the fan, or it is required by your local building codes, please follow the
wiring instructions below.
3.1 Wireless RF Control Kit Wiring
Your fan came pre-wired with the Wireless RF Control Kit. Simply mount the box onto a joist in your attic and plug
in the fan.
However, if your local building codes require you to hardwire your fan, simply remove the power cord and follow the
wiring instructions below.
1. Using a wire nut, connect the black wire from your two wire romex to the black wire from the Hub.
2. Connect the white wire from your two wire romex and the white wire on the fan to the white wire from the
Hub.
3. Connect the black wire from the fan to the blue wire on the Hub
4. Cap the yellow and red wires from the Hub.
5. Ground the green wire from the fan and the green wire from your two wire romex to the ground screw in
the Hub.
6. Set the dip switch positions inside the Hub as shown in the diagram below.
7. Power-on the Hub. The Power LED indicator will be lit.
4
CHECK TO MAKE SURE FAN BLADE SPINS FREELY AND THE FIRE DAMPER
MAKE SURE THE GARAGE FAN WILL NOT BACKDRAFT COMBUSTION
QUIETCOOLSYSTEMS.COM