Table of Contents
Advertisement
2.2 INSTALLING AFG VENT COVERS
Included with your QuietCool Attic Gable Fan are four vent covers
that are designed to be installed around the attic fan housing to
block any air backdrafting into the attic through a gable vent that
is larger than the attic fan cylinder, causing air to cycle in and out
around the vent.
1. Take the vent cover and match it to one of the sides around
the attic fan housing.
2. Using the two included Pan Head screws, attach each corner to
the wood framing around your gable vent.
3. Repeat step 1 and 2 for the three additional covers.
3. WIRING
IMPORTANT:
Wiring Diagrams are for examples ONLY. Wiring should be done by a licensed
!
!
electrician following local building and electrical codes and/or NEC guidelines.
NOTE:
Your fan came with the Adjustable Thermostat pre-wired on High Speed to a power cord for
! !
testing purposes before installation. If you would like to hard-wire the fan, or it is required by your
local building codes, please follow the wiring instructions below.
3.1
THERMOSTAT WIRING
1. For this installation, you will need a 2 wire Romex, and a thermostat.
2. Open up the thermostat that is connected to the fan. Remove the power cord. Bring your 2 wire
Romex from the power source into the thermostat.
3. With a wire nut, tie the white common wires together.
4. High Speed: Tie the black wire from the fan to one of the black wires from the thermostat. Cap the
red wire (see Figure 3.1A)
Low Speed: Tie the red wire from the fan to one of the black wires from the thermostat. Cap the
black wire (see Figure 3.1B)
QUIETCOOLSYSTEMS.COM
Installation Video:
Watch the video by scanning the QR
code or visit
www.QuietCoolSystems.com/support
Figure 2.1A
Figure 2.1B
7
Advertisement
Table of Contents
