Table of Contents
Advertisement
3. WIRING
NOTE:
Wiring Diagrams are for examples ONLY. Wiring should be done by an
!
!
experienced electrician.
NOTE:
Your fan came with the RF Hub pre-wired to a power cord for testing purposes before
! !
installation. The power cord can be used when installed inside of an attic. DO NOT USE THE
POWER CORD OUTDOORS. If you would like to hard-wire the fan, or it is required by your local
building codes, please follow the wiring instructions below.
3.1
ROOF MOUNT WHOLE HOUSE FAN WITH RF CONTROL
1. Using a wire nut, connect the black wire from the power source to the black wire from the Hub.
2. Connect the white wire from the power source and the white wire on the fan to the white wire
from the Hub.
3. Connect the red wire from the fan to the red wire on the Hub
4. Connect the yellow wire from the fan to the yellow wire on the Hub
5. Connect the black wire from the fan to the blue wire on the Hub
6. Ground the green wire from the fan and the ground wire from the power source to the ground
screw in the Hub.
7. Set the dip switch positions inside the Hub as shown in the diagram.
Figure 3.1A
Whole House Fan
8. Power-on the Hub. The Power LED indicator will be lit.
QUIETCOOLSYSTEMS.COM
Attach green ground wires to ground screw
POWER
TIMER
TEST
PAIR
All White Common Wires Together
Set dip switches:
1 - OFF
2 - OFF
3 - ON
ON
1
2
3
Power
Source
11
Advertisement
Table of Contents
