Installing Afg Vent Covers; Wiring; Two Speed Wiring - Afg Smt Pro-2.0 & 3.0 - QuietCool AFG Series Owner's Manual

NOTE: The AFG can be mounted on many other types of louvers, including triangle
vents, round vents, half-round vents, etc. If the vent is smaller than the area of the
fan, we recommend constructing a chamber that surrounds the vent, and then mount
the AFG to the chamber to ensure maximum airflow and performance.
2.2 Installing AFG (Attic Fan Gable) Vent Covers
Included with your QuietCool Attic Gable Fan are four vent covers
that are designed to be installed around the attic fan housing to
block any air backdrafting into the attic through a gable vent that
is larger than the attic fan cylinder, causing air to cycle in and out
around the vent.
1. Take the vent cover and match it to one of the
sides around the attic fan housing.
2. Using the two provided wood screws, attach each
corner to the wood framing around your gable
vent. (See picture for screw locations)
3. Repeat step 1 and 2 for the three additional
covers.

3. WIRING

NOTE: Wiring Diagrams are for examples ONLY. Wiring should be done by an experienced
electrician.
NOTE: Your fan came with the Smart Control Hub pre-wired to a power cord. Simply mount
the Smart Control Hub, find a power source in your attic, and plug the fan in. If you would
like to hard-wire the fan, or it is required by your local building codes, please follow the
wiring instructions below.
3.1. Two Speed Wiring - (AFG SMT PRO-2.0 & AFG SMT PRO-3.0)
1. Using a wire nut, connect the black wire from the power source to the black wire from the Hub.
2. Connect the white wire from the power source and the white wire on the fan to the white wire from
the Hub.
3. Connect the black wire from the fan to the blue wire on the Hub
4. Connect the red wire from the fan to the red wire on the Hub
4
How-to Video:
Watch the video by
scanning the QR
code or visit www.
QuietCoolSystems.com/
support
QUIETCOOLSYSTEMS.COM