Wiring; Wiring With A Thermostat - QuietCool AFG Installation Manual

3. WIRING

NOTE:
electrician.
3.1. Specialty Fan Wiring - Thermostat (see Figure 3.1A)
For wiring of a Specialty Series Fan with a thermostat. This wiring method works with all of our Specialty
Series fans, but we do NOT recommend using it with a Roof Mount fan that is being used as a whole house
fan. All fans wired on a thermostat must have enough continuous inlet venting (as stated in section 1.4).
1. For this installation, you will need a 2 wire Romex, and a thermostat.
2. Open up the junction box that is connected to the fan. Bring your 2 wire romex from the power source
into the junction box.
3. With a wire nut, tie the white common wires together. Using the green ground screw, ground the green
wire from the fan to the handy box.
NOTE: If you are NOT installing the thermostat in the junction box on the fan, continue to
step 7 to wire the thermostat.
4. With the thermostat, tie the black wire from the fan to the red wire on the thermostat.
5. Tie the two remaining black wires together.
6. Using the ground screw on the thermostat, ground your power source. Mount thermostat to junction
box.
Wiring the Thermostat Remotely (see Figure 3.1B)
7. Mount an electrical box for your thermostat in the best location for thermostat readings. Begin wiring
the thermostat.
8. With a 2 wire Romex, tie the black wire to the black wire from the thermostat.
9. Tape the white common wire on both sides of the 2 wire Romex because we will be using this as our
switch leg.
10. Tie the red wire and the taped white wire together.
8
Wiring Diagrams are for examples ONLY. Wiring should be done by an experienced
QUIETCOOLSYSTEMS.COM