HP ProLiant DL160 Gen8 Maintenance And Service Manual page 56

IMPORTANT:
To remove the processor:
Power down the server (on page 27).
1.
Remove all power:
2.
Disconnect each power cord from the power source.
a.
Disconnect each power cord from the server.
b.
Do one of the following:
3.
Extend the server from the rack (on page 27).
o
Remove the server from the rack (on page 28).
o
Remove the access panel
4.
Remove the processor air baffle
5.
Remove the heatsink ("Heatsink" on page 53).
6.
CAUTION: The pins on the processor socket are very fragile. Any damage to them may require
replacing the system board.
Open each of the processor locking levers in the order indicated, and then open the processor retaining
7.
bracket.
Processor socket 1 must be populated at all times or the server does not function.
("Access panel" on page 29).
("Processor air baffle" on page 30).
Removal and replacement procedures 56