Applications - GarrettCom magnum Installation And User Manual

Magnum Personal Hubs
network port.
Personal Workgroup connected
via front RJ-45 ports
2.4

Applications

Expanding from one to multiple ports at an existing site is easy, and
requires no modification to typical building wiring. The installer simply plugs the
existing networked device's network cable segment into one of the Personal Hub's
front RJ-45 ports. The Up-Link port (switch set to X) connects via 10BASE-T
cabling to the existing network outlet. (The H40A and H80A also allow backbone
connection via the rear-mounted AUI port. A mini-transceiver may be connected
to this port to provide connectivity to any standard Ethernet media type.) The unit
is powered by plugging the external power supply into an AC power receptacle,
and connecting the DC power cord into the back of the Personal Hub. In minutes,
up to eight (H80A and H90) additional ports are available for networked devices.
Additional user connected
via switchable up-link port
Personal Workgroup connected
via front RJ-45 ports
Personal Hubs may also be used as a stand-alone network for a personal
multi-user system such as shown to the right. Up to nine (H90) user ports are
available for 10BASE-T connection, and full-length Ethernet segments are
supported on all segments. In this application, the up-link switch is in the straight-
through (=) position so that the switchable port is a user port, not an up-link to
another hub.
w w w . G arrettC om . com
Installation and User Guide (09/01)
Existing
Switchable up-link
port (set to "X")
Switchable up-link
port (set to "=")
9