Installation - GarrettCom magnum Installation And User Manual

Magnum Personal Hubs
3.0

Installation

The installation
External
power supply
of a Personal Hub is a very
simple procedure. Locate
an AC receptacle that is
Personal Hub power
within six feet (2 meters)
connection - (H80A shown)
of the intended hub
location and plug in the external power supply (supplied with unit). The small DC
power cord from the power supply plugs into the rear power jack of the Personal
Hub. When power is applied the green PWR LED will be illuminated.
The external power supply unit supplied is one of two types; one for AC
power input of 115 vac 60 Hz, and one for 230 vac 50 Hz. Examine the power
supply to make sure the type is the right type for your AC power system. The 115
vac unit has a small transformer integral with a convenience power outlet plug.
The 230 vac unit has a small transformer integral with an IEC-type power plug for
a user-supplied AC power cord with a convenience power outlet plug. Both types
include a lightweight DC power cord for connection to the power jack on the
Personal Hub unit.
3.1 Table-Top or Shelf Mounting
Personal Hubs are easily mounted on a table-top or shelf, and have four
rubber feet to provide stability without scratching finished surfaces. A piece of
Velcro may be used to add additional stability if desired. When properly installed,
the top-view LED status indicators will be in plain view and easy to read.
The rugged steel case of the Personal Hub will protect it from accidental
damage in an office or lab workplace setting. Keep an open area around the unit so
that convection cooling can occur while the unit is in operation.
w w w . G arrettC om . com
Installation and User Guide (09/01)
10