Twisted Pair Connections; Aui Connection (Models H40A And H80A Only) - GarrettCom magnum Installation And User Manual

Magnum Personal Hubs
3.3

Twisted Pair Connections

1. Using standard
10BASE-T media, insert the
one end of the network cable
into one of the RJ-45 ports
on the Personal Hub. Even
though the hub's ports are of
Twisted pair connections -
the shielded type, they will
Magnum Personal Hub
accept and operate properly
with shielded and unshielded type RJ-45 twisted pair wiring.
2. Connect the other end of twisted pair segment to the desired
workstation or user device. The port's LINK LED will be lit when the connection
is made on both ends of the segment and DC power is present, i.e., when the
segment circuit is established and is ready to use.
3. For information on using the up-link port, refer to Section 3.5.
3.4

AUI Connection (Models H40A and H80A only)

Using the steps below
as a guide, attach a new or
existing 10BASE5 ThickNet
drop-cable directly to the AUI
connector on the rear of the
Magnum H40A or H80A.
Magnum H40A and H80A
1. Plug the male end of
the cable into the female AUI connector on the Personal Hub.
2. Engage the AUI connector slide lock to insure maximum connectivity.
3. Connect the opposite end of the cable into a network AUI port. (This
could be a network backbone transceiver, a hub or fan-out with an AUI port, or an
AUI Port Module in a concentrator.)
w w w . G arrettC om . com
Installation and User Guide (09/01)
AUI connection -
12