Chapter 2: Basic Operation
Preparing Omnii for Operation
Preparing 7545 for Operation
2.2
2.2.1
The Battery
Omnii is powered by a Lithium-ion Smart Battery pack, 5000 mAh—Model ST3000.
Important: Before charging the battery, it is critical that you review the battery safety
Battery packs shipped from the factory are charged to approximately 40% and must be fully
charged prior to use. Batteries can be charged using a variety of chargers and docking sta-
tions. For detailed information, see "Battery Details" on page 41.
Replacing the Battery Pack
Important: Always switch the unit off before changing the battery (see "Switching
Figure 2.6 Omnii Battery
1 - Release Latch
2 - Battery Compartment
3 - Guide Tabs
4 - Latch Tabs
14
Psion Teklogix Omnii Hand-Held Computer User Manual
guidelines in the Omnii Hand-Held Computer Regulatory & Warranty
Guide (PN 8000191).
Omnii On and Off" on page 15). However, assuming the default power
saving parameters and battery reserve level have not been altered, battery
swap time is a minimum of 5 minutes—you will not lose data if the battery
is replaced within this time frame.
1 2
1
Contacts
3
3
3
Battery Top
4
4
Battery Bottom